Property Manager Guide

Apartment Turnover Checklist for NJ Property Managers

An apartment turnover is the work between one tenant moving out and the next moving in: inspect, repair, paint, clean and re-key. In New Jersey there is one extra step for most rentals built before 1978. If the unit has no valid lead-safe certificate, it needs a lead paint inspection at tenant turnover.

This checklist from Strong Construction LLC follows the order a crew actually works in, so nothing gets painted before it is patched and nothing gets cleaned twice.

Before the tenant moves out

Confirm the move-out date in writing and book the walk-through for the same day. Pull the move-in condition report and photos so you can compare. Check the lead-safe status of the unit; if an inspection is needed, book it now, because paint repairs may have to happen before it. Order long lead items early: appliances, a vanity, a matching cabinet door, flooring. Tell your contractor how many units are turning and when, because a crew can plan three units in one building far better than three separate calls.

The New Jersey lead-safe step at turnover

New Jersey's lead paint law for rentals (P.L.2021, c.182) covers single-family, two-family and multiple rental dwellings. Units must be inspected for lead-based paint hazards every three years or at tenant turnover, whichever comes first. An inspection at turnover is not required if the owner has a valid lead-safe certificate, which is valid for two years. Homes built in 1978 or later are exempt, as are some other groups, including certain multiple dwellings registered with the state for at least ten years with no outstanding lead violations. Owners must report tenant turnover to the municipality, and hazards that are found must be fixed through abatement or lead hazard control. Source: NJ Department of Community Affairs, Lead-Based Paint in Rental Dwellings, read November 17, 2026. Towns run the program locally; in Fort Lee, for example, the Fire Prevention Bureau does the inspections. Peeling or chipping paint in an older unit is not just cosmetic. This article is not legal advice.

Walk-through: entry, kitchen and bathroom

Take photos of everything, including the things that are fine. Entry and hallways: door, frame, lock, peephole and closer; smoke and carbon monoxide alarms present, in date and working; fixtures, switches and cover plates; scuffs and dents. Kitchen: cabinet doors, hinges and drawer slides; countertop chips and the caulk line; sink, faucet, drain and shutoffs (look under the sink for leaks and swollen wood); run every appliance; backsplash tile and grout; the floor at the dishwasher and refrigerator. Bathroom: tub or shower surface, caulk and grout; loose or cracked wall tile and soft spots near the valve; toilet rocking, running or leaking at the floor; vanity, faucet and shutoffs; exhaust fan, mirror, towel bars and GFCI outlet; floor tile and threshold.

Walk-through: living room, bedrooms and the whole unit

Walls and ceilings: holes, anchors, stains and cracked tape joints. Windows: open, close, lock, screens and sills, checking paint condition closely on older windows. Closet doors, tracks, rods and shelves. Flooring: scratches, lifted planks, worn carpet and loose transitions. Test every outlet and switch. Radiators, baseboard covers or registers. Across the whole unit, look for leaks from above, pests, and anything the tenant altered.

Sort the list into three piles

Safety and code items (alarms, GFCIs, locks, leaks, paint condition in pre-1978 units) get done no matter what. Standard turn items (patch, paint, caulk, clean, minor hardware) should be the same scope and finish in every unit, which keeps turns fast. Upgrade decisions (new flooring, a vanity, a countertop, a bathroom or kitchen refresh) are decided per unit, based on condition and what the rent supports.

The order of work

1. Remove anything left behind and take out damaged items. 2. Plumbing and electrical repairs. 3. Drywall and plaster repair, tape and spackle. 4. Tile and grout repair, recaulk tub and counters. 5. Prime stains and patches, then paint ceilings, walls and trim. 6. Flooring repair or replacement. 7. Cabinet, door and hardware repairs; install fixtures, cover plates and blinds. 8. Appliances in and tested. 9. Final clean. 10. Re-key, final photos and a punch walk.

The punch walk

Walk the finished unit with the same checklist you used at move-out. Open every door and drawer, run every faucet, flip every switch. Mark what is left, send one list to the crew and close it out before the keys are released. A turn is done when the list is empty, not when the painters leave.

What to send a contractor for a quote

The address and how many units, with sizes; photos or a short video of each unit; your standard paint color and sheen and your flooring spec; the walk-through list sorted into the three piles; access rules for elevator, parking, work hours and key pickup; and the date each unit has to be rent ready.

How Strong Construction LLC helps

Strong Construction LLC is a licensed and insured interior renovation contractor based in Little Ferry, Bergen County (NJ Home Improvement Contractor #13VH13936900), with more than 20 years of work in New Jersey. For property managers and owners we do the interior side of a turnover: drywall, tape and spackle, painting, tile, flooring, trim, and kitchen and bathroom refreshes, in single units or across a building. See our apartment turnover contractor page. Send us the unit list and we'll quote it: call or text (201) 686-8232, or use the contact page.

What Every Project Includes

Written fixed-price scope before demolition
Permits filed and inspections managed for you
Dedicated project manager and shared schedule
Licensed NJ HIC #13VH13936900, fully insured
In-house carpentry and custom millwork
Daily site protection and clean-up
Allowances documented line by line
One-year workmanship warranty

Frequently Asked Questions

What is an apartment turnover?

It is the inspection, repair, painting and cleaning done between tenants so the unit is ready to rent again. Some managers call it a make ready.

Does New Jersey require a lead inspection every time a tenant moves out?

Not every time. Under P.L.2021, c.182, covered rentals are inspected every three years or at tenant turnover, whichever comes first, but an inspection at turnover is not required if the unit has a valid lead-safe certificate. The certificate is valid for two years. Homes built in 1978 or later are exempt. Source: NJ Department of Community Affairs.

What is the difference between a turnover and a renovation?

A turnover puts the unit back to rent-ready condition. A renovation changes it: a new kitchen, a new bathroom, new flooring throughout. Many owners do the larger work at turnover because the unit is empty.

What is a punch list?

The short list of items still open at the end of a job. The job is finished when every item on it is closed.

Get Started

Ready to Start Your Renovation?

Tell us about your project and we'll schedule a free, no-pressure site visit. We respond within one business day.

Free on-site consultation
Detailed written estimate
No-pressure, no-obligation

Prefer to pick a time? Book a free site visit.

Book a Free Site Visit

We respond within one business day. No spam, no pressure.

Call (201) 686-8232